Custom Made Chambers

Custom Made Chambers

Translate

Friday, February 16, 2024

EXTENDER Rods: How to Replace them

 REPLACING THE STANDARD SIZE RODS WITH THE XL RODS


CLICK BELOW TO WATCH THE TUTORIAL VIDEO




OK, to remove the standard length extender rods and replace them with the longer rods. 
This is what you’ll need to do. You need a 10 mm wrench or an adjustable crescent wrench. 
If you have one of the new extenders with the upgrade of the stable bar to prevent the twisting, then the first thing you need to do is just loosen these nuts and take them off. 
Disassemble these nuts off, take the stable bars off, remove this nuts and then you need to remove the spring bar which you can do by just doing this now. 
These thumb screws will have to come off. Also do both sides. You may have metal ones. We upgraded these to the brand here, so then the next thing you need to do, 
remove these also, or just loosen here on both sides. 
Righty tidy, lefty Lucy, and then just unscrew the threaded rod from the pelvic ring mounts. Take the nuts off and then reassemble using the long rods to screw the raw nuts onto each one and then put it back together the same way it was before. Back in the nuts backed off a little ways so that the rod fully threads down into the pivot mount and then take your ranch and snug that back up on both sides. So now we’re gonna go put everything back the way it was. Put both of these back on however long your penis is. You’re gonna make the adjustment and then like I said this this is goes back on like that. Both sides will go in here down there and then put the other thumbs on top reassemble the spring, the stable bar on top with the four nuts two on the bottom of this plate two on the top, snug it back up with your tender ranch or your adjustable crescent wrench and that’s it!


No comments:

Post a Comment